Level 1 and 2 Service Manual
Removing and Replacing the Display Assembly
6809456A82
1.
Remove the rear housing cover, SIM, endo assembly, front endo housing, and
battery, as described in the procedures.
2.
Use the disassembly tool to carefully release the 4 metal display latches on
each side of the display assembly as shown in Figure 10.
3.
Carefully lift the display assembly away from the transceiver board as shown
in Figure 10.
Figure 10. Removing the Display Assembly
4.
To replace, align the display assembly with the printed circuit board.
5.
Gently press the display assembly latches into position while holding the
display assembly in position.
6.
Replace the front endo housing, endo assembly, SIM, battery, rear housing
cover as described in the procedures.
January 23, 2003
DISPLAY ASSEMBLY
DISPLAY ASSEMBLY LATCH
DISASSEMBLY
TOOL
Disassembly
021030o
27