Battery Removal And Replacement - Motorola GSM 900/DCS 1800MHz Service Manual

Disassembly

Battery Removal and Replacement

G
E
26
Battery date codes are explained in the Battery Date Code section on page 14
Before handling the battery, please observe the battery cautions listed below.
Do not handle batteries with wet or sweaty hands.
Do not short the positive or negative terminals
Non conductive tweezers or grasping tools are to be used for battery connector
manipulation, assembly, and disassembly.
1. Remove the rear housing, SIM, endo assembly, and front endo housing as
described in the procedures.
2. Disconnect the battery connector from the connector socket as shown in
Figure 9.
3. Hold the battery by its case and remove it from the transceiver board. Do not
pull on the battery wires as they may become disconnected from the battery
pack or the battery connector.
DISASSEMBLY
TOOL
BATTERY CONNECTOR
Figure 9. Removing and Replacing the Battery
There is a danger of explosion if the Lithium ion battery is replaced incorrectly.
Replace only with the same type of battery or equivalent as recommended by the
battery manufacturer. Dispose of used batteries according to the manufacturer's
instructions.
4. To replace, align the battery connector cable with the battery connector socket.
The connector and socket are designed to maintain the correct polarity.
5. Replace the front endo housing, endo assembly, SIM, and rear housing as
described in the procedures.
August 20, 2002
TRANSCEIVER BOARD
BATTERY
Product Family 0C35
BATTERY SWITCH
6881040B65
020193o