Rapid Reading Of Alarms; Deleting The Last Alarm - Electrolux EWX13611 Service Manual

7.2.5

Rapid reading of alarms

It is possible to display the last alarm even if the selector is not in the eleventh diagnostics position or the
machine is in normal operation (e.g. while a washing programme is in progress):
→ Touch the START/PAUSE sensor and the nearest option sensor simultaneously (as if you were entering
DIAGNOSTIC mode) and hold for at least 2 seconds: the LCD display shows the last alarm.
→ The alarm will continue to be displayed until a sensor is touched.
→ The alarm reading system is as described in para. 7.2.
→ While the alarm is being displayed, the appliance continues to perform the cycle or, if in the programme
selection phase, it stores the previously selected options.
7.2.6

Deleting the last alarm

It is good practice to cancel the alarms stored:
after reading the alarm codes, to check whether the alarm re-occurs during the diagnostic cycle
after repairing the appliance, to check whether it re-occurs during testing
S1
Enter the diagnostic mode (para. 6.1).
Using sensor S1, select the position in which the LED lights up to display the alarms.
Simultaneously press the START/PAUSE sensor and the nearest option sensor (as shown in the diagram).
Keep your finger above the sensors (for approximately 5 seconds) until for styling P3.0 the display shows
"E00", while for styling P6 the START/PAUSE LED stops flashing.
N.B. With this operation all the alarms stored are deleted.
Technical Support - MDM
P3.0
S1
30/104
P6
599 77 39-16 Rev. 00