Table of Contents
Advertisement
Available languages
Available languages
General
DRAWERMAX
Drawer Warmers are designed for maximum
®
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power switch, unplug power cord/turn off
power at circuit breaker, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
+1-414-671-6350.
Casters
76 mm (3") casters are available for the freestanding unit in
place of the legs. Use the following procedure to install casters
onto the bottom of the unit.
NOTICE
Do not lay unit on the front or back side or damage to the
unit could occur.
1. Remove any pans from the drawers of the unit.
2. Carefully lay the unit on its left or right side (requires two
people).
3. Remove the legs, if installed.
4. Install the casters.
a. Align the four holes on the caster plate with the four
holes in the bottom of the unit at one corner of the unit.
b. Install a bolt through each of the holes in the caster plate
and into the bottom of the unit. Tighten securely.
c. Repeat steps a and b for the remaining three casters.
5. Return the unit to the upright position (requires two people).
Installing Casters
HDM_AAM-0623
Daily Cleaning
To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
1. Turn off the unit, unplug the power cord (freestanding
2. Remove and wash all food pans and accessories.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
3. Wipe down surfaces using a damp cloth. A non-abrasive,
4. Wipe dry the entire unit using a dry, non-abrasive cloth.
Water/Spillage Pan
The water/spillage pan fits in the drawer underneath the
food pan and can be used to humidify the heating area or
keep spillage from the cabinet interior. A Splash baffle is
recommended for use with a water/spillage pan.
Splash Baffle
The splash baffle is used with the optional water/spillage pan.
Fabricated of stainless steel, the baffle fits into the bottom of
the water/spillage pan, over the water bath. The splash baffle
prevents water from splashing into the cabinet interior when
opening and closing a drawer, while allowing humidity to escape.
Trivet
A trivet raises food product 13 mm (1/2") off the bottom of a full
size food pan.
152 mm (6") Food Pans
Accessory Full size stainless steel pan at 152 mm (6") deep —
324 W x 527 D x 152 H mm (12-3/4"W x 20-3/4"D x 6"H) are
available for all models.
76 mm
Caster
Bolt
11
models), and allow the unit to cool.
NOTICE
cream cleaner may be used for difficult stains.
• Make sure to check and clean the interior of the unit.
Food pieces may fall from the food pans into the drawer
cavity. CAUTION! BURN HAZARD — Do not clean
drawer cavity when unit is on or plugged in!
OPTIONS AND ACCESSORIES
MAINTENANCE
Advertisement
Table of Contents
