Installing Hdm-Xb And Hdm-Xbn Models - Hatco DRAWERMAX HDM Series Installation And Operating Manual

INSTALLATION
Installing the Anti-Tip Wall Bracket
Freestanding units may require anti-tip protection by installing
the Anti-Tip Wall Bracket supplied with the unit (available at
time of order from Hatco).
1. Move the unit to the desired location against the wall
where the wall bracket will be installed. Make sure the unit
has been properly leveled.
2. Loosen, but do not remove, the two screws that secure the
anti-tip plate to the top of the unit.
3. Determine the location of the wall bracket on the wall.
a. Position the wall bracket flush against the wall above the
unit.
b. With the locking tab handle pushed down on the
bracket, position the bracket so that the locking tab sits
completely inside the cutout on the anti-tip plate.
• Move the anti-tip plate back-and-forth as necessary
to properly seat the locking tab inside the plate.
Secure the plate to the unit once the proper location
is determined.
c. Mark the locations for the wall bracket fasteners through
the holes on the wall bracket.
4. Pre-drill the holes in the wall at the marked locations for
the appropriate wall bracket fastening system.
5. Install the wall bracket using the appropriate fasteners (not
included).
6. Lift the locking tab handle on the wall bracket, and move
the unit in position underneath the wall bracket.
7. Release the locking tab handle so that the locking tab sits
completely inside the cutout on the anti-tip plate.
Locking Tab Handle
Anti-Tip Wall Bracket
Screw
Anti-Tip Plate
(adjustable)
Installing the Anti-Tip Wall Bracket

Installing HDM-xB and HDM-xBN Models

HDM-xB and HDM-xBN models models are built-in units that
require installation into a cabinet before operation.
NOTE: Maintain a minimum clearance of 25 mm (1") between
Locking Tab
8
1. Cut the appropriate opening in the cabinet. Refer to the
"Built-In Cutout Dimensions" chart and illustration for
dimensions.
the cutout opening and the floor.
2. Fasten a locking strip (not supplied) to the lower front
inside lip of the cabinet opening.
3. Make sure a properly grounded electrical receptacle of the
correct voltage, size, and plug configuration is installed
inside the cabinet cutout. See the SPECIFICATIONS
section for details.
4. Plug the power cord on the unit into the electrical
receptacle.
5. Partially insert the unit into the opening, making sure the
power cord is fed into the opening first.
6. Before installing the unit into the opening completely,
apply a bead of National Sanitation Foundation-approved
sealant between the drawer warmer flange and the cabinet
facing.
7. Slide the unit into the opening until the front locking studs
drop behind the locking strip. To verify installation, pull out
bottom drawer completely and gently pull to ensure the
unit is locked in place.
Cabinet
Facing
Drawer
Warmer
Flange
Built-In Installation
Locking
Strip
Locking Studs
(underneath)
HDM_AAM-0623