Important Safety Information - Hatco DRAWERMAX HDM Series Installation And Operating Manual

Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded
electrical receptacle of the correct
voltage, size, and plug configuration. If
plug and receptacle do not match, contact
a qualified electrician to determine and
install proper voltage and size electrical
receptacle.
• Turn OFF power switch, unplug power
cord/turn off power at circuit breaker, and
allow unit to cool before performing any
cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if
unit has been submerged or saturated
with water.
• Unit is not weatherproof. Locate unit
indoors where ambient air temperature
is a minimum of 21°C (70°F).
• Do not steam clean or use excessive
water on unit.
• This unit is not "jet-proof" construction. Do
not use jet-clean spray to clean this unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed
or worn.
• Do not attempt to repair or replace a
damaged power cord. Cord must be
replaced by Hatco, an Authorized Hatco
Service Agent, or a person with similar
qualifications.
• Do not clean unit when it is energized or
hot.
• Do not allow liquids to spill into unit.
• Use only Genuine Hatco Replacement
Parts when service is required. Failure
to use Genuine Hatco Replacement
Parts will void all warranties and may
subject operators of the equipment to
hazardous electrical voltage, resulting
in electrical shock or burn. Genuine
Hatco Replacement Parts are specified
to operate safely in the environments in
which they are used. Some aftermarket
or generic replacement parts do not have
the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts.
If service is required on this unit, contact
an Authorized Hatco Service Agent or
contact the Hatco Service Department at
+1-414-671-6350.
HDM_AAM-0623

IMPORTANT SAFETY INFORMATION

FIRE HAZARD:
• Locate unit a minimum of 25 mm (1")
from combustible walls and materials.
If safe distances are not maintained,
discoloration or combustion could occur.
• Do not use harsh chemicals such as
bleach (or cleaners containing bleach),
oven cleaners, or flammable cleaning
solutions to clean this unit.
Make sure food product has been heated
to the proper food-safe temperature before
placing in unit. Failure to heat food product
properly may result in serious health risks.
This unit is for holding pre-heated food
product only.
This unit is not intended for use by children
or persons with reduced physical, sensory,
or mental capabilities. Ensure proper
supervision of children and keep them away
from the unit.
Make sure all operators have been instructed
on the safe and proper use of the unit.
This unit must be serviced by qualified
personnel only. Service by unqualified
personnel may lead to electric shock or burn.
BURN HAZARD:
• Some exterior surfaces on the unit will
get hot. Use caution when touching these
areas.
• Use caution when opening drawer. Hot air
escapes when drawer is open.
Standard and approved manufacturing oils
may smoke up to 30 minutes during initial
startup. This is a temporary condition.
Operate unit without food product until
smoke dissipates.
Locate unit in an area that is convenient for
use. The location should be level and strong
enough to support the weight of the unit and
contents.
Do not lay unit on front or back side. Damage
to unit could occur.
Use non-abrasive cleaners and cloths only.
Abrasive cleaners and cloths could scratch
finish of unit, marring its appearance and
making it susceptible to soil accumulation.
3
WARNING
CAUTION
NOTICE