Intec ColorCut SC6500 Installation Instructions Manual page 16

3. Make sure that the tool bracket is engaged on top of the tool's
flange, and then tighten the screw.
It is important, the Bracket to hold the Tool, is over the Flange as this
will hold the tool down. (If the Flange is above the bracket that holds the
tool, the tool height will be incorrect and the tool may gradually move up
during operation).
4. After fitting the Blade Tool in position 1, repeat the same process for the
Creasing Tool in Position 2.
SC6500
Bracket to
hold tool
Flange
Tool holder
N O
YES
3 January 2024
1-15
Intentionally blank
Installation Procedure