Intec ColorCut SC6500 Installation Instructions Manual page 12

Table of Contents

Advertisement

Caution:
It is recommended that minimum of four people carry out this task.
Warning:
Do not lift the unit from the bottom but use the handles [K] on the sides!
Pinch risk:
Keep fingers away from base of cutter when being lowered!
M
K
9. Remove the front drawer for easier access for lifting the unit.
10. The main unit has rubber feet (4x) [L] that match with holes (4x) [M] on
the support unit; these serve as guides to ensure that the main unit is
properly placed on top. Carefully lift the main unit by handles [K] with
one person on each side and one at front and back and place it onto
the support unit.
SC6500
Lifting point
11. Once the top half of the cutter is on the stand, secure the top to the stand.
Caution:
Avoid topple risk!
Cutter must be bolted securely to the cabinet stand.
K
Lifting point
12. Locate screws (4x) [N] on the sides and install washers (4x) and nuts (4x).
3 January 2024
1-11
To do so open the door and reach inside the machine.
N
L
Installation Procedure

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ColorCut SC6500 and is the answer not in the manual?

Table of Contents