Chapter 4. Connecting And Powering On The Cutter; Turning The Cutter On (The Initialisation Process) - Intec ColorCut LC600 Series Installation Manual

Chapter 4. Connecting and powering on the cutter.

4.1 Turning the cutter on (The Initialisation Process)

1.
Securely plug the power cord into the mains socket
connect to an electrical outlet of the specified voltage.
2.
Turn on the power using the mains switch
3.
The LCD Panel will illuminate and the Intec Logo will be displayed D, after approx
5 secs, the cutter will emit a beep sound and the tool carriage will move the
the far left position
will then boot, and the Wi-Fi function will initialise. After approx 35 -40 secs, the
illumination strip under the front cover will illuminate
be displayed on the LCD panel F. Once the HOME screen is displayed on the
LCD panel the cutter is Online and ready to use.
Intec Printing Solutions - Manual for ColorCut LC600 Sheet fed Label Cutter ........................................................................ Page No: 30
F (If not already in that position). The main control system
E
F
B
on the rear panel and
C
.
E and the HOME screen will
C
B
D
30 - 40 secs
initialisation
F