Dimmer Speed Mode; Color Calibration; Pulse Width Modulation; Display Invert - Chauvet Professional STRIKE Array 4C User Manual

Operation

Dimmer Speed Mode

To set the dimmer speed:
1. Go to the Dimmer Mode main level.
2. Select the dimmer speed mode from Off (instant), Dimmer 1 (fastest), Dimmer 2, or Dimmer 3
(slowest).

Color Calibration

To configure the color calibration:
1. Go to the Color Calibration main level.
2. Select from Off, User Calibration, or Factory Calibration.
3. If User Calibration, select the maximum color value to edit, from Red, Green, Blue, Amber, or
White.
4. Set the maximum level for the selected color, from 125–255.
5. Repeat until the colors are calibrated as desired.

Pulse Width Modulation

To set the frequency of the pulse width modulation:
1. Go to the LED Frequency main level.
2. Select the PWM frequency, from 600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25KHz.

Display Invert

To invert the display:
1. Go to the Display Invert main level.
2. Select from No (does not invert the display) or Yes (inverts the display).

Fan Mode

To set the fan mode:
1. Go to the Fan Mode main level.
2. Select the fan mode, from Auto (adjusts to product temperature), On (always on), Off (always off),
or Silent (silent mode).

Display Backlight

To set how long the display will stay lit without activity:
1. Go to the Back Light main level.
2. Select from 10S (10 seconds), 30S (30 seconds), 2Min (2 minutes), or Always On.

Key Lock

To lock or unlock the control panel:
1. Go to the Settings main level.
2. Select the Key Lock option.
3. Select On (locks control panel) or Off (control panel stays unlocked).
When the key lock is activated, the product will prompt for the passcode in order to
access the menu. The passcode is <UP>, <DOWN>, <UP>, <DOWN>, <ENTER>.

Information

To view product information, such as the number of hours the product has been on, the driver firmware,
etc., go to the Information main level.

Temperature

To view the temperatures of the LEDs, driver boards, or the display board in °C, go to the Temperature
main level.

Factory Reset

To reset the product to factory default settings:
1. Go to the Factory Reset main level.
2. Select No (do not reset) or Yes (reset).
STRIKE Array 4C User Manual Rev. 1 21