Figure 4.6 Electrical Connections From Controller To An Ultraseal 20 Actuator - Branson Emerson Ultraseal 20 Operating Manual

Figure 4.6
4.5.5 Setting Weld Height Proximity Switch
Tools Required-2mm Allen wrench, 2.5mm Allen wrench, Feeler gauge set, Dial caliper.
Parameter Settings- System must be setup to run in the energy mode.
The preheight and height are used for quality monitoring. Refer to Touchscreen Controller
Instruction Set portion of this manual for more information.
42
Electrical Connections from Controller to an Ultraseal 20 Actuator
DCM00051 REV. 10