Branson Emerson Ultraseal 20 Operating Manual page 51

The cable lengths are limited based on the operating frequency of the welding system.
Performance and results can suffer if the RF cable is crushed, pinched, damaged or
modified. Contact your Branson Representative if you have special cable requirements. In
some cases, remote operation from a User I/O or a Remote Terminal can be used to solve
a distance limitation.
4.5.2 Input Power (Main)
The system requires single-phase input power, which you connect to the Controller using
the integral power cord. See
requirements for your specific power level.
Refer to the unit's Model Data Tag to be sure of the power rating of the Model in your
system.
4.5.3 Output Power (RF Cable)
Ultrasonic Energy is delivered to a screw-on MS receptacle connection on the rear of the
Controller, which is connected to the Ultraseal 20 Actuator.
WARNING
4.5.4 Interconnect Between Controller and Actuator
The Ultraseal 20 Actuator has three electrical connections between the Controller and the
Actuator: the RF Cable, the Control Data Cable, and the Touchscreen Control Cable.
There can be other connections to the Actuator, and other connections to the Controller,
but these are the three standard connections, depicted in
DCM00051 REV. 10
Table 4.3 Input Power requirements
Never operate the System with the RF Cable disconnected or if the RF
Cable is damaged.
for plug and receptacle
Figure 4.6.
41