Bundled with this manual are the respective manufacturers instructions and manuals for the branded parts that are fitted to your Whyte bike. Please take time to study all the rele- vant instruction manuals to ensure you have a continually safe and well set-up bike before every ride, and to help you build up a relationship of knowledge between you and your Whyte Dealer.
Race Face www.raceface.com components on you Whyte bike, then DO Shimano www.shimano.com NOT RIDE YOUR BIKE. Contact your Whyte dealer who will be able to advise SR Suntour www.srsuntour-cycling.com you on how to go about setting up you SRAM www.sram.com...
Seat Post. 3.3: WHYTE INTER-GRIP SEAT CLAMP ADJUSTMENT The Inter Grip 2 seat clamp design is present on several models of Whyte bikes. It allows adjustment of the saddle height & direction. Fig.2: Inter-Grip Seat Clamp...
Page 7
Good Quality Shock Pump. Small Ruler The front suspension fork fitted to your Whyte bike will be pre-set with the standard settings. Before riding, you may need to adjust these setting. First is the Sag setting on the fork. This is to ensure the forks are set-up correctly for your own body weight, so the fork will perform as intended.
If you are in any doubt about one or more components on your Whyte DO NOT RIDE YOUR BIKE. Consult the specific component manufacturers literature, or take your bike to your local Whyte Dealer.
WHYTE Service Manual 5.0: LUBRICATION Please refer to the Whyte General Instruction Manual for guidance about lubricating many of the components on your Whyte bicycle. For the range of bicycles contained in this Supplementary Service Manual, there is also the following specific guidance: 5.1: WHYTE GETTA-GRIP SEAT CLAMP...
WHYTE Service Manual 5.3: GENERAL WHYTE LUBRICATION For the correct lubrication regime and maintenance of all parts on a Whyte bicycle, please refer to the specific component manufacturers detailed instructions bundled with this man- ual or for further information visit the specific manufacturers website.
WHYTE Service Manual curved edges are not engaging properly, so re-align as necessary to make sure both of the Sleeves (2 & 4) are nearly flush to the side of the Main Frame (5). Then follow the instructions in section 3.3 to set the height and direction of the Seat Post (not shown).