Disassembly Procedures; Removing And Replacing Range; Front Control Panel; Maintop Assembly - Maytag AGR5715QD Service Manual

Disassembly Procedures

!

Removing and Replacing Range

1. Turn off power to the range at the circuit breaker.
2. Turn off gas supply line to unit.
3. Pull the range forward out of the cabinet opening.
4. Unplug the power cord leading from unit to outlet.
5. Replace the range using the installation instructions
and anti-tip bracket(s).

Front Control Panel

1. Open or remove oven door from unit.
2. Remove control knobs from gas valves, by pulling.
3. Remove screws securing front control panel, located
on the bottom edge of the front control panel.
4. Remove control panel by sliding one way or the other
and pulling away from the unit.
5. Reverse procedure to reassemble.

Maintop Assembly

1. Turn power off to unit.
2. Remove front control panel, see "Front Control Panel"
procedure.
3. Remove grates and caps.
4. Remove screws securing top surface burner to
maintop.
5. Lift surface burner off.
6. Raise the front edge of the maintop and pull forward.
7. Lift maintop assembly from the oven chassis.
8. Reverse procedure to reinstall maintop assembly.

Control Panel

1. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 7.
2. Remove screws securing control panel heat shield.
3. Remove screws securing bottom outside edges of the
control panel.
4. Pull unit out from the wall far enough to allow the
back outside screws to be loosened.
5. Loosen the back outside screws securing control
panel to backguard.
6. Grasp front lower outside edges of the control panel
and push inward on the outside edges of the
backguard to release the control panel front.
NOTE: Front edges of the control panel are difficult to
release from backguard.
7. Once the control panel bottom edges are free, pull
control panel forward and raise the control panel
upward to release screws securing top back edges
and allow control panel to tip forward.
8. Reverse procedure to reinstall control panel.
©2003 Maytag Appliances Company
WARNING
16022498 Rev. 0
To avoid risk of electrical shock, personal injury, or death:
disconnect electrical and gas supply before servicing.

Control Board Assembly

1. Remove control panel, see "Control Panel"
procedure, steps 1 through 6.
2. Remove screws securing control board bracket to
control panel.
3. Label and disconnect terminal plug from control
board assembly.
4. Reverse procedure to reinstall control board
assembly.

Rocker Switch

1. Remove control panel, see "Control Panel" procedure
for removal.
2. Disconnect and label wire terminals from rocker
switch.
3. Squeeze tabs on rocker switch and push outward to
release from control panel.
4 . Reverse procedure to reinstall indicator light.

Top Surface Valve and Spark Switch

1. Remove control panel, see "Front Control Panel
Removal" procedure.
2. Remove spark switch by pulling straight off valve.
3. Remove screw securing valve to front manifold.
4. Replace and reassemble in reverse order.

Top of Surface Burner

1. Turn off electrical power and gas to the range.
2. Disconnect gas and power from unit.
3. Remove grates and caps.
4. Remove screws securing top surface burner to
maintop.
5. Lift surface burner off.
6. Replace and reassemble in reverse order.

Bottom of Surface Burner

1. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 7.
2. Remove nut securing burner tubing to surface valve.
3. Replace and reassemble in reverse order.
29