Safety; Export - ergoline CLASSIC 8000 ULTRA Operating Instructions Manual

Please read and observe ...

Safety

Danger!
Assembly and electrical connection must comply with the na-
1)
tional regulations.
Assembly, installation, upgrading or repair of the device may
only be carried out by specially trained and instructed person-
nel.
• All danger and safety notes attached to the device must be observed!
• No safety equipment (e.g. panel switch) or safety notes may be re-
moved or deactivated which can impair the safe operation of the de-
vice!
• The device may only be operated in proper condition!
• Assembly is only permitted following the prescribed stages in these
instructions!
• In all dismantling and assembly work on electrical systems, the de-
vice is to be disconnected from the power supply (see Page 23). Ex-
ceptions are permissible only for function tests!
• The device operating time must be dual controlled with a timing de-
vice to the standards EN 60335-2-27 and A1 2000 Section 22.108
and 22.109. A timing device must be designed so that the device is
automatically switched off at the latest after 110% of the selected op-
erating time even when the controller fails.
1) In Germany: VDE regulations
• Do not change, obstruct or block the air inflow and outflow area to the
device or make any unauthorised changes to the device. The manu-
facturer shall bear no liability for damage or injuries resulting from
such actions.
• Before putting a tanning device into operation, the transport pallet
must be removed from under the device. Danger of overheating by
obstruction of the air routing.

Export

We emphasise that these devices are intended for the European market
and must not be exported to nor operated in the USA or Canada!
The manufacturer shall assume no liability whatsoever in case of non-ob-
servance! We explicitly emphasise that high liability risks may occur for
the exporter an/or the operator in case of non-observance.
21