Heavy duty 24 volt dc linear actuator for residential / light commercial use (14 pages)
Summary of Contents for Maximum Controls MAX WIRELESS EDGE 900
Page 1
QUICK INSTALLATION GUIDE MAX WIRELESS EDGE 900 www.max.us.com www.max.us.com RESIDENTIAL / COMMERCIAL APPLICATION 200 FT RANGE Battery Life: 2 yrs Max Wi Tx Max Wi Tx Edge 1 Edge 2 Max-WETX Max-WETX 10K Opening 10K Closing Edge Edge (Sold Separately)
Page 2
TABLE OF CONTENT www.max.us.com www.max.us.com Max Wireless Edge Wi Edge KIT Overview Wi Edge Receiver Installation Overview Installing Opening 10k Edge using Wi Tx Edge 1 Installing Closing 10k Edge using Wi Tx Edge 2 RF Channel Selection RF Power Lever Selection Troubleshooting...
Page 3
MAX WIRELESS EDGE KIT OVERVIEW www.max.us.com Max Wi Tx Max Wi Tx Edge 2 Edge 1 www.max.us.com Max-WETX Max-WETX HOUSING BATTERY HOLDER PAIR POWER PAIR 200 FT RANGE BUTTON (LINE OF SIGHT) PLUG Max Wi Edge Receiver Max-WETX EDGE 1 EDGE 2 RF CHANNEL RF POWER LEVEL...
Page 4
MAX WIRELESS EDGE RECEIVER INSTALLATION www.max.us.com A Max Wi Edge Receiver module can communicate with two wireless edge www.max.us.com transmitters. For instance one for OPENING direction and one for CLOSING. Wi Tx Edge 1 can be used for OPENING 10k Edge and Wi Tx Edge 2 for CLOSING 10k Edge. INSTALLING WI EDGE RECEIVER MAX SLIDER OPERATOR...
Page 5
INSTALLING OPENING 10K EDGE USING TX EDGE 1 SINGLE GATE www.max.us.com www.max.us.com MATRIX III Plug Wi Edge Receiver connector with adaper board to “Module Port” of Matrix III Plug cable with blue connector to “UL Sensors 10K” port Install Wi Tx Edge on gate so it is in line-of-site with Wi Edge Rx...
Page 6
INSTALLING OPENING 10K EDGE USING TX EDGE 1 www.max.us.com SINGLE GATE www.max.us.com INSTALLING OPENING 10K EDGE Install the OPENING 10K edge sensor on the gate Mount the Wi Tx Edge 1 housing next to the 10K Edge on the front side of the gate using self tapping screws Loosen bottom 2 screws and pull down plug to remove it...
Page 7
I T 1 L I M O S I E N I I T S L I M I T 2 L I M I T 1 L I M L L E I T S L I M I T 2 L I M / O F T I O...
Page 8
INSTALLING OPENING 10K EDGE USING TX EDGE 1 www.max.us.com ENTRY/EXIT AND DUAL GATES www.max.us.com ENTRY / EXIT ADJACENT GATES ENTRY GATE EXIT GATE Set ENTRY GATE Set EXIT GATE Wi Edge Rx & Tx 1 and 2 Wi Edge Rx & Tx 1 and 2 on RF CHANNEL 1 on RF CHANNEL 2 refer to next page for instruction...
Page 9
RF CHANNEL SELECTION OPTIONAL FEATURE www.max.us.com www.max.us.com Select a different RF Channel if you have the following conditions: 1) Entry/Exit Gates or nearby adjacent gate that also has Wi Edge 900 installed 2) Dual Gates. Secondary gate that also has Wi Edge 900 installed 3) “Tx Offline”...
Page 10
PAIRING WI EDGE RX AND WI EDGE TX 1 & 2 www.max.us.com www.max.us.com Unpair Wi Edge Rx from Wi Edge Tx 1 & 2 PRESS and HOLD the PAIR BUTTON on Wi Edge Rx until Pair OK LED turns OFF (do this for Edge 1 &...
Page 11
LOAD LOAD MOTOR 1 OPENING OPEN CLOSING LIMITS LIMIT 2 OBD PORT D POR BLACK BOX ACK B LIMIT 1 MAXIMUM CONTROLS RESET MOTOR 2 DSP ARM CONTROLLER LIMITS LIMIT 2 ON/OFF ON/O ALARM BATTERY BATTE PROGRAMMING OGRA MOTION CONTROL...
Page 12
TROUBLESHOOTING www.max.us.com SYMPTOM POSSIBLE CAUSE SOLUTION www.max.us.com 1) To unpair them, press PAIR button on Wi Tx Edge 1 (or 2) for at least 5 1) Wi Tx Edge 1 (or 2) could be already sec. Then press corresponding PAIR paired.
Page 13
TROUBLESHOOTING www.max.us.com SYMPTOM POSSIBLE CAUSE SOLUTION www.max.us.com 1) Check if Batt Low LED is ON, indicating low battery if so change “RANGE OK” Poor range is detected between Wi batteries LED is OFF Edge Rx and Wi Tx Edge 1 (or 2) for Edge 1 (or 2) 2) Wi Tx Edge 1 (or 2) is too far away.