Advertisement
PAIRING WI EDGE RX AND WI EDGE TX 1 & 2
1
Unpair Wi Edge Rx from Wi Edge Tx 1 & 2
PRESS and HOLD the PAIR BUTTON on Wi
Edge Rx until Pair OK LED turns OFF
(do this for Edge 1 & 2)
2
PRESS and HOLD the PAIR
BUTTON on the Wi Tx Edge 1
until PAIR LED turns OFF.
3
PRESS and HOLD the PAIR
BUTTON on the Wi Tx Edge 2
until PAIR LED turns OFF.
4
Power cycle Wi Edge Tx 1 & 2 by
removing and reinstalling their
batteries
5
Push the PAIR BUTTON on the
Wi Tx Edge 1 circuit board.
Pair LED will start blinking
Go to the Wi Edge Receiver and PUSH
6
the PAIR BUTTON for Edge 1. PAIR LED
for Edge 1 will become solid when pairing
process is successful.
Troubleshooting: if PAIR LED keeps blinking, pairing has failed.
Ensure Wi Tx Edge 2 is within range of Wi Receiver.
Check if the RF Channels of Wi Edge Rx matches RF channels of Wi Edge Tx
(Refer to RF Channels Selection page).
7
Repeat steps 5 and 6 to PAIR Wi
Tx Edge 1 to Wi Edge Rx
PAIR
PAIR
LED
Button
PAIR
PAIR
Button
LED
PAIR
PAIR
LED
Button
www.max.us.com
www.max.us.com
10
Advertisement
