Advertisement
INSTALLING
www.max.us.com
www.max.us.com
Go to the Wi Edge Receiver and PUSH
8
the PAIR BUTTON for Edge 1. PAIR LED
for Edge 1 will become solid when pairing
process is successful.
Troubleshooting: if PAIR LED keeps blinking, pairing has failed.
Ensure Wi Tx Edge 1 is within range of Wi Receiver.
Check if the RF Channels of Wi Edge Rx matches RF channels of Wi Edge Tx (see page 7).
6
For additional info check troubleshooting page.
OPENING 10K EDGE
SINGLE GATE
4
Remove Wi Edge Tx circuit
board by sliding it out of
housing (remove board
by gently pulling down
the jumper cable on the
5
Install 2 batteries on circuit
board following battery
orientation on battery
holder.
USING
TX EDGE 1
INSTALLING
1
Install the OPENING 10K edge sensor
on the gate
2
Mount the Wi Tx Edge 1 housing next to
the 10K Edge on the front side of the gate
using self tapping screws
3
Loosen bottom 2 screws and pull
down plug to remove it
EDGE 10K
6
Connect the 10K edge wires to
the Wi Tx Edge 1 circuit board,
screw terminals. (Feed 10k Edge
wires through plug first)
7
Push the PAIR BUTTON on the
Wi Tx Edge 1 circuit board.
Pair LED will start blinking
PAIR
PAIR
LED
Button
9
OPENING
10K EDGE
Reattach PLUG to housing
and secure it with 2 screws
(provided)
Advertisement
