Advertisement
SYMPTOM
Unable to PAIR
Wi Tx Edge 1 (or 2)
to Wi Edge Rx
Pair LED
Blinking
Wi Edge Rx or Tx
"TX OFFLINE"
LED is ON
for Edge 1 (or 2)
"EDGE NOT DETECTED"
LED is ON
for Edge 1 (or 2)
TROUBLESHOOTING
POSSIBLE CAUSE
1) Wi Tx Edge 1 (or 2) could be already
paired.
Need to unpair Wi Tx Edge 1
(or 2) from its original Wi Edge Rx
2) Wi Tx Edge 1 (or 2) are too far away
from Wi Edge Rx.
Tx or Rx PAIR
LED Blinking indicate pairing mode
1) Wi Tx Edge 1 (or 2) is not powered
ON. Battery is not installed or batteries
are low
2) Wi Tx Edge 1 (or 2) is out of range of
the Wi Edge Rx
3) Wi Tx Edge 1 (or 2) is NOT paired to
Wi Edge Rx
10K Edge is not detected on Wi Tx
Edge 1 (or 2).
SOLUTION
1) To unpair them, press PAIR button
on Wi Tx Edge 1 (or 2) for at least 5
sec. Then press corresponding PAIR
button on Wi Edge Rx also for at least 5
seconds. Try pairing again by following
pairing sequence. (See p 5-6)
(Power cycle Wi Tx Edge 1 (or 2) - If
necessary)
2) Move Wi Tx Edge 1 (or 2) closer to Wi
Edge Rx. Try pairing again by following
pairing sequence. (See p 5-6)
Pair with corresponding
device Rx or Tx
(Refer to pairing on page 5, 6 )
1) Install or replace batteries on Wi Tx
Edge 1 (or 2)
2) Move Wi Tx Edge 1 (or 2) closer to Wi
Edge Rx
(Refer to pairing on page 5, 6)
Install a 10K Edge on Wi Tx Edge 1 (or 2)
www.max.us.com
www.max.us.com
12
Advertisement
