Advertisement
General
J
Hinge
Roller
pin
Hinge
arm
hook
Care
Fig. 1
Fig. 2
& Cleaning
Care and Cleaning
of Stainless Steel (Some models)
Some models are equipped
with stainless steel exterior
parts. Special
care and
cleaning
are required
for maintaining
the appearance
of stainless parts. Please
refer to the table
provided
at the beginning
of the General
Care & Cleanlng
section in this Use & Care Guide.
nd Aeplacing
the Lift-Off
Oven Door
he door is heavy. For safe, temporary
storage,
lay the door flat
with the inside of the door facing
down.
To Remove
Oven
Door:
1.
Open oven door completely
(horizontal
with floor
= See Fig. 1).
2.
Pull the door hinge locks on both left and right door hinges down from the oven
frame completely
towards
the oven door (See Fig. 2). A tool such as a small
flat=blade
screwdriver
may be required.
3.
Firmly grasp both sides of oven door along the door sides (Do not use the oven
door handle
= See Fig. 3).
4.
Close the door to about
a 10 degree angle
as shown in Fig. 3.
5.
With the oven door in this position,
lift the oven door hinge arms away from
the roller pins located
on each side of the oven frame
(See Fig. 4).
door
Fig. 3
Fig. 4
To Replace
Oven
Door:
1.
Firmly grasp both sides of oven door along the door sides (Do not use the oven
door handle
= See Fig. 3).
2.
Holding
the oven door at the same angle as the removal
position,
seat the hook
of the hinge arm onto the roller pins located
on each side of the oven door
frame (See Fig. 4). The hook of the hinge arms must be fully seated onto the
roller pins.
3.
Fully open the oven door (horizontal
with floor = See Fig. 1).
4.
Push the door hinge locks up towards
and into the oven frame on both left and
right oven door hinges (See Fig. 2) to the locked
position.
5.
Close the oven door.
Speclal
Door
Care
instructions
- Most oven doors contain glass that can break.
Read the following
recommendations:
1.
Do not close the oven door until all the oven racks are fully in place.
2.
Do not hit the glass with pots, pans, or any other object.
3.
Scratching,
hitting, jarring
or stressing the glass may weaken
its structure
causing an increased
risk of breakage
at a later time.
31
Advertisement
