Advertisement
Consumer Defined Control
Setting Temperature
Display-
Fahrenheit
or Celsius
Flex
The
and Cbon pads control the Fahrenheit
or Celsius
temperature
display
modes.
The oven control can be programmed
to display
temperatures
in Fahrenheit
or Celsius. The oven has been preset at the factory
to display
in Fahrenheit.
Note: both
ovens will be changed
at the same time.
INSTRUCTIONS
PRESS
DISPLAY
To change
dlsplay
from
Fahrenheit
to Celsius or Celsius to
Fahrenheit
1.
Press _
and hold for 7 seconds. A beep will sound, "550" will
appear
"UPPER" and "BROIL" will flash in the display
(Fig. 1).
After 6 seconds a beep will be heard and "F" (Fig. 2) or "C" (Fig.
3) will appear
in the display.
.
If "F" appears,
the display
is set to show temperatures
in
Fahrenheit
(Fig. 2). If "C" appears,
the display
is set to show
temperatures
in Celsius (Fig. 3).
Flex
Press Clean to switch between Fahrenheit
or Celsius display
modes.
The display
will show either "F" (Fig. 2) or "C" (Fig. 3).
3.
Press _
to accept
the change
or press _
to reject the change.
_
or
_for
7seconds
Fig. 1
Fig. 2
Flex
Clean
Fig. 3
Setting Accent Light
Your range includes a decorative
Accent
Light centered
horizontally
across touch-sensitive
control
panel. The Accent
light
comes with a theatre
style intensity feature
that slowly increases brightness
at turn on and slowly fades when turning
off.
When the Accent
light is off, the light is in automatic
mode. This means the Accent
light will turn on automatically
when an
oven or Timer has been activated.
The Accent
light will turn off automatically
when these functions
are no longer active.
Accent
When the Accent
light is OFF, it may be turned ON by pressing
Lightonce. When the Accent
light has been manually
turned
Accent
on, it will remain
on until manually
turned off by pressing
Light again. The brightness
may also be adjusted.
INSTRUCTIONS
Example
- To adjust the Accent llght brightness:
1.
PRESS
DISPLAY
Accent
Press and hold
Light until an acceptance
tone sounds (about 6
seconds)
2.
The default
setting of 100 wiii appear
in the display
(See Fig. 4).
3.
Using the numeric
keypad,
enter any digit from 0 to ]00
to
change
the brightness
level. Entering 0 (Fig. 5) wiii effectively
turn the Accent
light OFF until the brightness
level is adjusted
to a
higher level.
4.
Press _T_ to save the desired
brightness
setting.
Accent
Light
Value between
0 to 100
@
Fig. 4
Fig. 5
Operating
Oven Lights
The interior oven lights will turn ON when the oven door is opened.
Press _ to turn oven light ON an OFF whenever
the oven door is dosed.
The interior oven lights are located on the rear wall of the oven interior and are covered
with a glass shield. The glass shield
protects
the bulb from high temperatures
and should always
be in place whenever
the oven is in use.
To replace
the interior oven lights, see Replacing oven llghfs in the Care and Cleaning
section.
Advertisement
