Advertisement
WARNING
How to Install Light Plate
Fg.7
Fan LED Light Model
Install the LED light kits as illustrated above.
How to Install / Remove the Cover
Fg.8
Fan Only Model
NB: There is no cover for Fan Only Model.
Installing Receiver Remote Control
Installing Receiver Remote Control
Wire up the receiver with quick connectors and insert into
Wire up the receiver with quick connectors and insert into
the mounting bracket. Make sure the antenna wire has been
the mounting bracket. Make sure the antenna wire has been
(DO NOT cut the antenna wire)
(DO NOT cut the antenna wire)
E: sales@martecltd.com.au | P: 02 8778 7500
www.martecaustralia.com.au
Fg.9
Fan LED Light Model
Align the convex point on the light plate with the gap
Important Reminders
Important Reminders
•
•
Receiver must be correctly installed in the
Receiver must be correctly installed in the
mounting bracket
mounting bracket
•
•
When the transmitter cannot control the
When the transmitter cannot control the
receiver, please check
receiver, please check
ii) any existence of similar remote
ii) any existence of similar remote
controlled products nearby that cause
controlled products nearby that cause
interference
interference
•
•
sensitivity of the transmitter
sensitivity of the transmitter
•
•
Take the battery out from the transmitter
Take the battery out from the transmitter
when leaving used for a long time to avoid
when leaving used for a long time to avoid
battery leaks
battery leaks
•
•
Isolation switch MUST be connected in the line
Isolation switch MUST be connected in the line
Advertisement
