Related Manuals for Lincoln SKF PowerMaster III
Summary of Contents for Lincoln SKF PowerMaster III
- Page 1 User instructions PowerMaster III drum pumps Models , , and , ball-type foot valve Date of issue October Form number Version ...
- Page 2 Contents Declaration of Incorporation .. U.K. Declaration of Incorporation .. Safety .........
- Page 3 //EC appropriate. EN ISO : Safety of machinery. General principles I, the undersigned of Lincoln Industrial for design. Risk assessment and risk Corporation, do hereby declare that the reduction equipment specified above, in its intended use, conforms to the requirements of the above EC Directive(s).
- Page 4 I, the undersigned of Lincoln Industrial Corporation, hereby declare that the equipment specified above, in its intended use, conforms with the Essential Health and Safety Requirements of U.K. legislation Supply of Machinery (Safety) Regulations No. Annex I, Declaration of Incorporation by the time of placing it on the market.
-
Page 5: Explanation Of Signal Words For Safety
Explanation of signal words Safety CAUTION for safety Do not operate equipment without The assembly must be installed, maintained wearing personal protective gear. and repaired exclusively by persons familiar Wear eye protection. Protective with the instructions. equipment such as dust mask, non-skid NOTE Always disconnect power source Emphasizes useful hints and... -
Page 6: Appropriate Use
Do not operate equipment with Appropriate use combustible gas. Do not attempt to repair or WARNING Use Lincoln replacement parts to assure disassemble equipment while system Ground pump, dispensing valve and compatible pressure rating. is pressurized. containers when handling flammable... -
Page 7: Operation
Operation NOTE Flush pump before use to prevent contamination of pumped material. Attach air motor to Pumps are factory tested with light oil pump tube and some remains to protect pump parts during storage and transportation. Attach tie rods tightly to airmotor (use short threaded end of tie rods). -
Page 8: Tools Required
Procedure Disassembly Remove foot valve body () from Tools required bushing tube (). • Strap wrench, in diameter Slide retaining pin () from foot valve • Hex wrench, body () and remove ball (). • Hex wrench, ... - Page 9 Fig. Dimensions NPTF Ø 2 Pump Pump Ratio Delivery pressure Air pressure Dimension Dimension tube model motor ) maximum maximum : . . : ...
- Page 10 Fig. IPB 10 11 ) On models , and only. ) On model only. ) Included in piston repair kit. ) Included in piston repair kit. ) Included in piston repair kit )Torque to – lbf-ft (– Nm) ) Torque to –...
- Page 11 Parts list Part number Item number Description Quantity Model Model Model Model Bolt connector ) Plunger Gland nut ...
-
Page 12: Troubleshooting
Troubleshooting Problem Possible cause Solution Pump does not operate. Restricted or inadequate air supply. Check air supply pressure and air hose diameter (refer to air motor manual for minimum air supply hose diameter). Obstructed material output. Check output line for restrictions. Erratic or accelerated operation. - Page 13 This page left intentionally blank. ...
- Page 14 This page left intentionally blank. ...
- Page 15 This page left intentionally blank. ...
-
Page 16: Warranty
® SKF and Lincoln are registered trademarks of the SKF Group. © SKF Group The contents of this publication are the copyright of the publisher and may not be reproduced (even extracts) unless prior written permission is granted. Every care has been taken to ensure the accuracy of the information contained in this publication but no liability can be accepted for any loss or damage whether direct, indirect or consequential arising out of the use of the information contained herein.
Need help?
Do you have a question about the SKF PowerMaster III and is the answer not in the manual?
Questions and answers