Honda HS828 Manual page 34

HS928
4) Position the stop against the chute guide lever, and tighten the
nuts
SERVICE BULLETIN #22 =>
FUEL TANK/FUEL FILTER
• Gasoline is extremely flammable and is explosive under
I
o
certain conditions. Do 'not smoke or allow flames or
sparks in the area.
After installing the fuel tank and filter, check for leaks,
and make sure the area is dry before starting the engine.
1) Remove the fuel tank after drain the gasoline from the fuel tank
completely
2) Disconnect the fuel tube and remove the fuel filter.
3) Clean the fuel tank with solvent and dry the fuel tank
completely.
4) Clean the fuel filter with compressed air and check it for
damage.
5) Place the 0-ring on the filter and reinstalL
Tighten the fuel filter to specifed torque
TORQUE: 2 N·m (0.2 kg-m, 1.4 ft-lb)
DRIVE BELT
1. DRIVE CLUTCH LEVER STROKE
ADJUSTMENT
1) Depress the drive clutch lever gradually and adjust so that the
drive clutch lever stroke is 140- 143 mm (5.5 -5.6 in) at the
point where the pulley starts to move.
2) To adjust the drive clutch lever, loosen the clutch cable lock nut
and turn the adjusting nut.
After adjustment. tighten the lock nut securely and recheck the
drive clutch lever stroke.
Start the engine, and make sure that the drive belt does not
rotate when the drive clutch lever is disengaged.
HONDA
HSB2B
CHUTE GUIOE LEVER
!'C'!c:===
ORIVE CLUTCH LEVER
LOCK NUT
0-RING
140 ~
143 mm
)5.5 - 5.6
inl