Honda HS828 Manual page 48

c. REASSEMBLY
• RECOIL STARTER ASSEMBLY
The recoil rope must be oiled prior to installation to prevent freezing,
which may make the recoil starter inoperative
1) Cut 137 em (54 in) of #5 recoil rope from your bulk supply.
2) Soak the recoil rope in engine oil.
3) Use a shop towel and squeeze the excess oil from the rope.
4) Pass the rope through the hole in the starter reel, and tie the
end of the rope.
Next, wind the rope onto the reel in the indicated direction, and
wedge the end of the rope in the notch on the edge of the reel.
5) Insert the hook on the outer side of the spring into the hole
<A>
in the spring case. wind to the right, and attach the hook
on the spring's inner end on the groove <B> inside the starter
case
6) Install the starter reel assembly into the starter case.
Take care so that the hook on the inner side of the spring does
not come off.
(It
is advrsable to rnsert while turning to the left.)
HS928
E OIL
. .
THOROUGHLY
NOTCH
RETURN
SPRING
----"".,"""'--STARTER
CASE
ROPE
EL