Honda HS828 Manual page 35

HONDA
HSS2S
2. DRIVE BELT TENSION ADJUSTMENT
1 I Adjust the belt stoppers (P 3-1 1 I
HS928
2) Check the distance between the drive tension roller and engine
head as shown is 171
~
174 mm (6.7- 6.9 in) when the drive
clutch lever is disengaged.
To adjust the distance, loosing the drive clutch cable lock nut
and turning the adjusting nut.
3) After adjustment, tighten the lock nut securely and recheck the
distance.
Start the engine, and make sure that the drive belt does not
rotate when the drive clutch lever is disengaged.
AUGER BELT
1. AUGER TENSION ROLLER POSITION
ADJUSTMENT
1) Adjust the auger tension roller with the long hole in the tension
arm so that the tension roller comes to the complete outside
(cable side) position.
NUT
AUGER
TENSION
ROLLER
DRIVE CLUTCH
CABLE
PULLEY
TENSION~ ~\f'r.
ARM
~~
AUGER TENSION ROLLER
OUTSIDE
(CABLE SIDE)
INSIDE
(ENGINE SIDE)