Honda HS828 Manual page 42

HS928
HONDA
HBB2B
ENGINE REMOVAL/INSTALlATION
1. ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL/INSTALLATION
1)
Remove the 6 x 12 mm flange bolt, collars and belt cover.
2) Remove the chute guide cable from the chute guide.
3) Remove the 8 x 28 mm flange bolt, 8 mm washer, drive pulley (drive and auger) and woodruff key.
NOTE:
!
Be careful not to lose the woodruff
key.
4) Remove the 6 x 12 mm flange bolt from the chute handle.
NOTE:
Engine can be removed without removing the chute handle holder and chute drive gear.
5) Disconnect the engine switch wire and ground cable.
6) Disconnect the throttle cable from the control plate.
7) Remove the four 10 mm flange nuts, and remove the engine.
GROUND CABLE
10 mm FLANGE
NUT
HANDLE HOLDER---',-y
BOLT
6
X
12
TH
CABLE
ENGINE
SWITCH
I
ADJUSTMENT; P. 3-9)
- - - - - - - -
WOODRUFF
KEY
AND AUGER
BELTS
8
X
28
CHUTE GUIDE
CABLE
)ADJUST8MENT:
P.
~
I
I