Honda HS828 Manual page 33

HONDA
HSB2B
CARBURETOR
HS928
1) Start the engine and allow it to warm up
to
normal operating
temperature.
2) Move the throttle lever SLOW position to allow the engine to
idle.
Turn the throttle stop screw to obtain the standard idle speed.
[Standard idle speed
I
2,1 00 ±150
min-' (rpm)
3) With the engine idling, turn the pilot screw in or out to the
setting that produces the highest idle rpm.
The correct setting will usually be obtained at approximately
the following number of turns out from the fully closed (lightly
seated) position.
I
Pilot screw opening
I
2 turns out
NOTE:
If pilot screw adjustment greatly increases engine rpm, read-
just the idle stop screw.
CHUTE GUIDE CONTROL CABLE
1) Adjust the chute guide cable
by
its adjusting nut (chute guide
lever side) so the chute guide is in the most raised position
when the chute guide lever moves "UP" position.
2) Loosen the nuts on the chute guide lever stop (p. 3-6).
3) Lower the chute guide by the chute guide lever to the position
where clearance between chute guide and chute is
1-3
mm
(0.04 - 0.12
in).
- - - - - -
\\
THROTTLE STOP SCREW
CHUTE GUIDE
LEVER
PILOT SCREW
CHUTE GUIDE
1 - 3mm
(0.04 - 0.12 in)
CHUTE