Honda HS828 Manual page 36

2. AUGER CLUTCH LEVER STROKE
ADJUSTMENT
1) Depress the auger clutch lever gradually and adjust so that the
auger clutch lever stroke is 140-143 mm (5.5 -5.6 in) at the
point where the auger tension roller starts to move.
Adjustment should be made by loosening the auger clutch cable
lock nut and turning the adjusting nut.
2) Start the engine and check the belt.
When the auger rotates;
Set the belt stopper to the standard position so that
it
does not
contact with the belt stopper (P. 3-11 ).
When the auger slips;
Slide the auger tension roller to the center.
NOTE:
• Make sure that the belt rotates whenever you slide the
auger tension roller to the center.
1
•
When replacing the belt with a new one, it is not necessary
L
to slide the auger tension roller to the center.
3. AUGER CLUTCH LEVER ADJUSTMENT
To
adjust the auger clutch lever affects the function of the drive
clutch operating together
with
the auger clutch and the bell
tension. Be sure to adjust as following;
1)
Depress the auger clutch lever.
2)
Depress the drive clutch lever.
3) Release the auger clutch lever and lock it while keeping the
drive clutch depressed.
4) Adjust the auger clutch lever so that the clearance between the
tip of the auger clutch lever and the handle grip is 10-15 mm
(0.4- 0.6
in). Adjustment can be made by loosening the two
cap nuts and moving the lever.
5) After the adjustment, tighten the cap nuts securely and relock
the auger clutch lever. Make sure that the clearance is as
specified.
4. AUGER BRAKE ADJUSTMENT
1) Start the engine and rotate the auger with the auger clutch
lever depressed. Engine speed should be as below.
[Engine speed
I
3,600 min- 1 (rpm}
~-------~~------~~------~
2) Release the auger clutch lever
and
make sure
that the
auger
stops rotating within
5
seconds.
3) If
not,
loosen
the auger clutch cable and adjust so as to stop
within
5
seconds.
NOTE:
je
Be sure that the clutch lever stroke is as specified in step 2.
I _
in the previous page while adjusting the auger clutch cable.
~
__ B_e_s_u_r_e_t_o_fo __ llo_w __
i_n_o_rd_e_r_o_f_s_t_e~ps
__
1_._•h_r_o~u~g_h_4_.
________
~
H5928
140- 143 mm
(5.5- 5.6 in)
HONDA
HSB2B
LOCK NUT
ADJUSTING
NUT
OUTSIDE
(CABLE SIDE)
INSIDE
(ENGINE SIDE)
10-15mm
(0.4 - 0.6 in)
T
AUGER
TENSION
ROLLER
AUGER CLUTCH LEVER
AUGER DRIVE .