Table of Contents
Advertisement
SECTION
i ·
INSTALL.\
TION
F.
Testing the lnstaUation
1. Turn all range and oven controls to the OFF position.
2. Tum main power disconn(lcf switch to ON.
3. Check ran gs top components by tu ming one control on at a time starting at the left side ot the control panel.
Check that the component is starting to heat and then tum it off.
4, Check the oven controls.
a. Deck oven - Set thermostat control at 300"F (149"C). Tum both the upper and lower heating element
switches to LOW. Check that both the upper and lower elements are starting to heat and then !urn them
to OFF.
b. Convection oven - Set thermostat control to 300"F (149°C). Push Ian switch LOW position. Turn oven
power switch ON. After a fow minutes open oven door and check for heat If oven Is heating tum all controls
to
OFF.
0, Marine Oven Range Installation on Curb
1.
Installation of Oven Range on meta.I curb (shipped separately)
a. Boll or weld base flange of metal curb {R/N33669) to floor of ship. See figure 2~2.
b. Position oven range on curb as shown in Figure 2·3.
c. Remove oven sido covers and use existing mounting holes to boll oven range to top flange of curb.
2.
Installation of Oven Range on existing cum,
Page 12
a. Existing curb must be ventilated as shown on metal curb in Figura 2·3. The opening for circulation must
equal 8 square ft.(0.74 square meters)
b. Remove oven side covers and use existing mounting holes
10
bolt ovon range to top of curb.
Fig. 2·2
Metal curb
Range
lnstal1ation & Operations Manual 1189331 Rev 1 (08/10)
Curb
Fig. 2~3
Oven
range
on curb
Advertisement
Table of Contents
