Making Terminal Rear Panel Connections; Terminal Keyboard Connection; Datacomm Connection - HP HP700/92 User Manual

Making Terminal Rear Panel Connections
Refer to Figure 1-3 when making all cable connections on the terminal's rear panel.
Figure 1-3. Terminal Rear Panel Connections
0
1) Port I (Datacomm)
3) Keyboard Connector
(i) 0
2) Port 2 (Printer)
4) Power Connector
Terminal Keyboard Connection
One end of the keyboard cable is connected to the keyboard as described earlier in this
chapter. Connect the other end to the terminal's rear panel. The connector clicks into
place when installed correctly.
Datacomm Connection
The Datacomm cable is the link from your terminal to a host computer. In its standard
configuration, the terminal communicates with a computer through Port 1 over an
RS232C datacomm cable.
To connect the datacomm cable to your terminal, perform the following steps:
1.
Insert the RS232C connector into the socket provided in po11 1 on the terminal. The
connector shell is shaped so that it fits onto the socket in the correct position.
2.
After fully inserting the connector into the socket on the terminal, tighten the two
screws that secure the connection.
Installation 1 ·3