Printer Connection; Power Cable Connection; Terminal Controls - HP HP700/92 User Manual

NOTE
If you use Port 2 for your datacomm connection. be sure to
configure your terminal properly (see Chapter 2).
Printer Connection
Port 2 provides a standard RS232C connector for connecting a printer. To connect a
printer cable to Port 2, follow the instructions for connecting a datacomm cable (the
connectors are the same in both cases). Remember, if you use Port 2 as your datacomm
rather than Port 1 , be sure to configure the terminal appropriately.
Power Cable Connection
An appropriate power cable is supplied with your terminal.
WARNING
Turn the terminal off before applying power. The power
button on the front lower left-hand corner of the terminal
is flush with the front panel when the terminal is off (see
Figure 1-4). Also, for your safety, use only power cords with
a 3-prong connector.
Insert one end of the power cord into the AC socket on the back of the terminal. Then
plug the 3-prong connector on the other end of the cable into an electrical outlet.
Terminal Controls
To tum on the terminal, make sure it is connected to a power source. Press the power
button shown in Figure 1-4. The button remains depressed in the ON position.
1-4 Installation