Removing The Display Panel - HP Engage One Retail System 141 Maintenance And Service Manual

Removing the display panel

You must remove the display panel from the computer head unit to access internal computer components.
1. Prepare the computer for disassembly
2. Remove the computer head unit from the stand
the stand on page
3. Loosen the three captive screws in the slot on the bottom of the computer head unit.
4. Separate the computer's display panel from the computer head unit at the connection points, and then
lift the display panel up approximately 2.5 cm (one inch).
IMPORTANT:
An internal cable must be disconnected before the display panel can be fully removed.
5. Holding the display panel 2.5 cm (one inch) from the computer head unit, shift the display panel forward
no more than 7.5 cm (three inches) (1) to access the display cable connection. Lift the edges of the tape
that covers the display cable connection (2), and then disconnect the display cable from the connector
on the system board (3) by pulling the tab on the cable end.
IMPORTANT:
reconnected.
(Preparation for disassembly on page
27).
Do not lift the display panel higher than 2.5 cm (one inch) from the computer head unit.
Be careful not to fold the edges of the tape. It must be replaced when the display cable is
(Removing and attaching the Engage One head unit to
19).
Removing the display panel 41