Turning The Terminal On And Off - HP HP700/22 User Manual

Turning the Terminal On and Off
After following the installation steps, you're ready to turn on the terminal. Press the
power button on the front left of the terminal. The button remains recessed while the ter-
minal is on.
You'll hear two beeps when you turn on the terminal. The terminal performs a quick
self-test every time it's powered on. If there are any problems, refer to Chapter 4,
"Troubleshooting" .
After the self-test is done, the screen display comes on. In Chapter 3, "The Display
Screen" section provides an illustration of what the screen may look like when it
comes on.
To turn the terminal off, push the power button again so that it is flush with the front
panel.
Adjacent to the power button is an entry door to the front of the display unit. Un-
obtrusive in appearance, this door is provided for terminal service functions. Pushing
down lightly on the door opens it. Moving it gently back it into place closes it.
Figure 1-3. Terminal Controls
1) Tilt and Swivel Pedestal 2) Power Switch 3) Service Door
4) Contrast Control 5) Brightness Control
Installation 1·5