Table of Contents
Advertisement
vehicle speed exceeds the set speed by about
3 mph (3 km/h). At the same time, a wa rning
symbo l appears in the display. The symbol's
appearance might be different in some mod-
els.
The speed warning system has two warning
thresholds that function independently of
each other and that have somewhat different
purposes:
Speed warning 1
You can use speed warnin g 1 to set the maxi -
mum speed w hile you are driv ing. This sett ing
will remain in effect until you t urn off the igni -
tion, assuming that you have not changed or
reset the setting.
The .
(USA
models);a
(Canada models)
speed warning symbol in the warning 1 dis-
play appears when you exceed t he maximum
speed. It goes out w hen t he speed fa ll s below
the stored maximum speed.
The speed warning symbo l wi ll also go out if
the speed exceeds the stored maximum speed
by more than about 25 mph (40 km/h) for at
least 10 seconds. The stored maximum speed
is deleted .
Speed warning 2
Storing warn ing 2 is recommended if you al-
ways want to be reminded of a certa in speed,
for example when you are traveling in a coun-
try that has a general maximum speed li mit,
or if you do not want to exceed a specified
speed fo r winter tires.
The .
(USA mode ls)/ .
(Canada models)
speed war ning 2 symbo l appears in the dis-
play w hen you exceed t he stored speed lim it.
Unlike war ning 1, it will not go out unti l t he
vehicle speed drops below t he stored speed
limit.
Setti ng speed wa rning 2 <=;>
page 79 .
@
Tips
Even t hough you r vehicle is equipped with
a speed wa rning system, you should st ill
On the
road
79
watc h the speedo met er t o make sure yo u
are not dr iving faste r t han the speed li mit .
Speed warning 1: setting a speed limit
Warning threshold 1 is set by the
!SE T I
but -
ton.
Fig. 79 SE T but ton in the instr um ent cluste r
Storing the maximum speed
.. Drive at the desired maximum speed.
.,. Press the
!SE T I
button in the instrument
panel display ¢ fig . 79 for 1 second.
Resetting the maximum speed
.. Drive the vehicle at a speed of at least
3 mph (5 km/h)
.,. Press the
ISE T I
button for more than 2 sec-
onds.
The .
(USA models)/ .
(Canada models)
speed warning symbo l wi ll appear brief ly in
the display when you release the
!SE T I
button
to indicate that the maximum speed has been
stored successfully .
The maxim um speed rema ins stored until it is
changed by pressing the
!SE TI
button again
briefly or until it is deleted by a lengthy push
on the button.
Speed warning 2: setting a speed limit
The radio or MMI* control unit is used to set,
change or delete warning th reshold 2.
.,. Select:
I
CA R I
function button> Instrument
cluster > Speed warning .
Or
.,. Select:
I
CAR I
function butt on
>
Car systems
cont rol butto n
>
Driver assist
>
Speed warn-
ing .
II>
Advertisement
Table of Contents
