Table of Contents
Advertisement
26
Dr iv er in f ormation
d is play
¢ fig . 10 .
The data from the single -trip mem -
ory (memory leve l 1) is being displayed if a
D
appears in the display . If a
II
is shown, then
the data from the total -trip memory is being
d isplayed (memory leve l 2). The fuel pump
nozzle
iii
indicates the efficiency program*
¢ page 27 .
Single-tr ip m emory (Trip computer 1)
The single-trip memory stores the trip infor-
mat ion from the time the ignition is turned o n
until it is turned off. If the trip is continued
within 2 hours from the t ime the ignition was
turned off, the new data will be included in
the calcu lation of the current trip info rma-
tion . If the t rip is inte rrupted fo r more than
2
hours the memory is reset automati ca lly.
Total -trip memory (Trip computer 2)
Unlike the sing le-trip memory, the tota l-tr ip
memory is not reset automatically . This per-
mits you to evaluate your d riving data for the
enti re pe riod be tween manual rese t s.
Efficiency
program*
The effic iency program can help you to use
less fuel ¢
page 2
7.
Operation
The trip compu ter is controlled by two
switches on the windshield wiper lever.
Fig. 11
Wind shield wipe r lever: cont ro ls fo r th e t rip
comp ute r
.. To d isp lay the trip computer memory levels,
press t he
I
RES ET
I
button @ ¢
fig. 11
re-
peatedly unt il the desired memory leve l is
shown in the d isplay.
.. To display tr ip informat ion wit hin a memory
level, press the top or bottom part of the
function se lection switch @ .
The t rip computer will not ope rate un less the
ignition is on. When you t urn on the ignition,
the function that was in use when you last
turned the ignition off will be displayed .
In add ition to info rmation on the t rip comput -
er (trip computer 1 and 2 and the efficiency
program *), the digital speedometer
and infor-
mation regard ing the navigat ion system* can
also be displayed. To switch the d isp lay be-
tween the different information, tap the
I
RESET !
button @ briefly.
Sett ing values to zero
To de lete one current value from the trip com -
puter, se lect the des ired funct ion and press
t he
I
RES ET
I
button @ for at least one second.
The following values can be set to zero indi-
vidually:
- Average fue l mi leage
- Average speed
- Elapsed t ime
- Dist ance
All cur rently d isplayed values are deleted in
the eff iciency program*.
In add it ion, all the values in the single-trip or
the total-tr ip memory can be de leted simulta-
neously ¢
page 26.
(D
Tips
All stored va lues will be lost if the veh icle
battery is discon nected .
Basic Settings for the trip computer
The radio or MMI* operating unit is used for
setting the trip computer's basic se t tings.
.. Select: Function button
ICAR !
> Instrument
cluster > On-board computer 1 or On-board
computer 2 .
The values in the sing le-trip or the total -t rip
memory can all be reset to zero at the same
time under Reset in the menu.
...
Advertisement
Table of Contents
