Table of Contents
Advertisement
120
Homelink®
Programming the transmitter
(version
A)
Applies to vehicles: with Homelink
Fig. 123
Head line r : controls
Fig. 124
Distance between the radiator grille and the
hand transm itter
You can program the fixed code and rolling
code systems using the described procedure.
Programming the button
.,. Turn the ignition on .
.,. There are two ways to program the button:
Press the button
q
fig. 123 that you would
like to program . Use the instructions that
appear in the MMI* to perform the program-
ming. Or
.,. Select :
~IC~A~R~I
function button > Car sys-
tems* control button
>
Vehicle settings>
Garage door opener> Program garage door
opener.
.,. Select the button that you would like to
program.
.,. Follow the instructions in the MMI*.
.,. If the garage door opening must also be
synchronized with the Homelink module,
refer to the owner's manual for the garage
door opener.
Remote control units for garage door openers
in Canada are set to stop transmitting
radio
frequency signals after two seconds. This time
may not be sufficient for the Homelink sys-
tem to learn the radio frequency signal. Per-
form all other steps as described above.
Operating the button
.,. Press the programmed button to open the
garage door. The LED@ blinks or illumi-
nates .
.,. Press the button again to close the garage
door.
Erasing/Clearing the programmed button
settings
.,. To erase all of the programmed buttons at
the same time, select:
I CAR !
function button
>
Car System* control button
>
Vehicle set·
tings
>
Garage door opener> Clear pro-
gram settings> Yes. The programmed
but-
tons can not be erased individually . Repro-
gram the buttons if necessary .
.,. Reprogram an individual button in the same
manner that you would for the one-time
programming .
Displaying the version/status/country
code
.,. Select:
!CAR !
function button> Car sys-
tems* control button > Vehicle settings >
Garage door opener > Version information .
@
Tips
- Programming using the MMI* is not
available for all vehicle versions.
- The required distance between the hand
transmitter
and the Homelink module in
the radiator grille
q
fig. 124 depends on
the system that you are programming .
- Depending on the model of the garage
door opener, you may need to release the
button on the remote and press it again
when programming. When program-
ming a new device, keep the button
pressed for at least 15 seconds before
trying again with the transmitter
in a dif-
ferent position . Watch out for the emer-
gency flasher during that time.
.,..
Advertisement
Table of Contents
