True XC900 Owner's Manual page 20

STEP 4—ATTACH DRAWBARS AND DRAWBAR COVERS
Tools Used in this Step
6mm Allen Wrench
17mm Socket
#2 Phillips Screwdriver
1. Attach each drawbar to its corresponding shaft using
2 bolts, 2 lock washers, and 2 fl at washers, but do not
tighten.
NOTE: The drawbars are labeled L for left and R for
right.
2. Using a 17mm socket, tighten the 2 bolts, 2 lock
washers, and 2 fl at washers.
PX0154
SX0099
PX0153
20
Parts Used in this Step
PART DESCRIPTION
XCS0362BK SUBASSEMBLY, DRAWBAR, LEFT
XCS0363BK SUBASSEMBLY, DRAWBAR, RIGHT
CE90172BK COVER, OUTER, LEFT
CE90173BK COVER, INNER SIDE COVER, LEFT
CE90174BK COVER, INNER, RIGHT
CE90175BK COVER, OUTER, RIGHT
PX0153 HHS, M10-1.5 X 20MM, ZP
SX0099 LOCK WASHER, M10, BLK, ZP
PX0154 WASHER, FLAT, M10 X 35MM OD X 2MM, BLK
XC90050 SCHS, M8-1.25 X 12MM
XC90051 WASHER, M8 X 14MM OD X 2MM
CX0102 PHMS, M3-0.5 X 12MM, BLK
SX0004 PHMS, M5-0.8X12MM, CRE, RE
3. Attach the bottoms of the drawbars to the base using 8
hex screws and 8 curved washers, but do not tighten.
4. Using a 6mm allen wrench, tighten the 8 hex screws
and 8 curved washers.
XCS0363BK
QTY
XC90050
XC90051
1
1
1
1
1
1
2
2
2
8
8
6
4