Table of Contents
Advertisement
STEP 1—ATTACH PEDESTAL
Tools Used in this Step
#2 Phillips Screwdriver
8mm Allen Wrench
1. Using a #2 Phillips screwdriver, remove the left and
right inner shrouds from the base using 6 screws.
XCS0351BK
16
Parts Used in this Step
PART
XCS0350BK
XCS0351BK
XCS0074
XCS0365
CX0501
CX0510
XCS0096
XCS0313
CX0501
CX0510
DESCRIPTION
COVER, INNER FRONT SHROUD, LEFT
COVER, INNER FRONT SHROUD, RIGHT
RUBBER RING
ASSEMBLY, PEDESTAL, XC900
PHMS, M5-0.8 X 12MM
PHMS, M5-0.8 X 25MM
SHCS, M10-1.5 X 20MM, LP, BLK
SHCS, M10-1.5 X 70MM, BLK
2. Remove the twist tie from the rubber seal and slide
it up over the weld beads to its correct location.
Make sure the UP tab is facing up on the rear of the
machine.
NOTE: The rubber seal is for perspiration defl ection
and should sit below the plastic covers.
XCS0074
UP tab
QTY
1
1
2
1
4
2
8
4
Advertisement
Table of Contents
