Monitoring The Device - Kaco blueplanet 29.0TL3 Manual

Manual
Upload/download
4 4
1 2 3
Download service log
data
Download service log
data without yields.
Download a set of pa-
rameters
Document a set of pa-
rameters
Transfer a set of para-
meters
AVISO
With regard to the selection of country settings, KACO new energy attests:
1. that the relevant certificates are only valid if the corresponding country settings have been selected.
2. that all configured grid parameters must be configured in accordance with the requirements of the grid
operators.
3. that the configuration of parameters using IEEE 1547: 2003 table 1 is possible but is only permitted if it is
requested by the grid operators.
9.5

Monitoring the device

The device has an integrated web server. This makes it possible to monitor and record the operating state and
yield of your PV system.
USB interface
Use an external USB storage device to read operating data saved on the device.
Reading log data
1. Connect a suitable USB storage device to the USB interface on the connection circuit board.
2. Open the "Log data view" menu.
3. Select "Save to USB".
4. Select the desired log data using the 4-way button.
5. Press the Enter button.
ð The device saves the selected log data to the USB storage device.
AVISO
The USB interface is approved solely for use with USB flash storage devices ("USB sticks"). The maximum availa-
ble current is 100 mA. If a device with a higher power requirement is used, the power supply for the USB inter-
face automatically shuts down to protect the device from damage.
Web server
This device has an integrated web server. After configuring the network and activating the web server in the Settings me-
nu, you can open the web server from an internet browser. The language version of the website delivered by the web ser-
ver is adapted dynamically to the pre-set language preferences in your Internet browser. If your Internet browser re-
quests a language that is unknown to the device, the web server uses the menu language set in the device.
↻ You have connected the device to your network.
1. When using a DHCP server: Activate DHCP.
2. For manual configuration (DHCP off):
3. Open the Settings/Network menu.
Kaco blueplanet 29.0TL3
Configuration and operation | 9
AVISO: Opportunity to save log files and save and import pa-
rameter data
F Save service log data to external storage media.
F Save log data without yields to external storage media.
F Save a set of parameters to external storage media.
F Issue or print documentation of a set of parameters as a PDF.
F Load a set of parameters from external.
Página 55