Commissioning; Requirements; Preconditions Relating To Standards - Kaco blueplanet 29.0TL3 Manual

8 | Commissioning

8 Commissioning
8.1

Requirements

PELIGRO
Lethal voltages are still present in the connections and cables of the device even after the device
has been switched off and disconnected!
Severe injuries or death may occur if the cables and/or terminals/busbars in the device are touched.
1. The device is only permitted to be commissioned by a qualified professional.
2. Unauthorised persons must be kept away from the device.
↻ The device has been mounted and electrically installed.
↻ The PV generator supplies a voltage above the configured start voltage.
1. Connect the grid voltage using the external circuit breakers.
2. Connect the PV generator using the DC isolator switch (0 > 1)
ð The device begins operation.
ð During initial start-up: Follow the instructions of the New Connection Wizard.
8.2

Preconditions relating to standards

Attachment of safety label in accordance with UTE C15-712-1
The code of practice UTE C15-712-1 requires that, upon connection to the French
low-voltage distribution network, a safety sticker showing a warning to isolate both
power sources when working on the device must be attached to each device.
F Attach the provided safety sticker to the outside of the device housing where it is
clearly visible.
Página 34
Manual
ATTENTION Isoler les deux sources
Présence de deux
avant toute intervention
sources de tension
- Réseau de distribution
-Panneux photovoltaïques
Fig. 41: Safety label UTE C15-712-1
Kaco blueplanet 29.0TL3