Kenwood TM-732A Instruction Manual page 80

BRACKET Se Via
Loosen the bracket screws and put the two plates i
right angles. Attach the front panel unit to the bracket
using the three supplied screws.
Install the bracket using the supplied flat washers and
; Fa Cover
feed ri d Microphone
Self Tapping Screw
Panel Cable (4m) Microphone Cable (2m) e
q) S Flat Washer
— as
PG-4L
2 S
- <By
DC Cable (6m) Speaker Cable (5m)
a. | Screws
<1 Self Tapping Screw
3x6
@ Installation Using Velcro Fastener
NOTE
The bracket may come off due to vibration or shock
when installed using Velcro. Install the assembly in a
safe position near the console, or storage compart-
Coe tate _ | ment (indicated by the lines) to ensure safety.
Pr JO? me | Peel the backing on the supplied Velcro tape and attach
} reenesese) ©) . it to the back of the front panel unit. Securely install the
Panel Cable (7m) Microphone Cable (5m) front panel in a stable position.