Mufre 206 Vars Rdoa Mamois Oe 4. Separating Rx Audio Signals; Entering Data Into Memory - Kenwood TM-732A Instruction Manual

5. Select any digit from 0-9 by rotating the Tuning
control, or by pressing the UP/DWN switches on
the microphone, then press the SHIFT/DTSS key.
(Or press the desired number on the microphone
keypad. This will enter the number and advance
you to the next number position without having to
press the SHIFT/DTSS key again.).
. After you select the first digit a beep will sound and
the middle digit will begin flashing. Select the next
number by using any of the methods described
above.
. Select the final digit as described above. After the
last digit has been entered the display will return to
the normal frequency mode, indicating the tone
selection process has been successfully
completed.
NOTES
i. If a key other than the DTSS key is pressed during
the code selection procces, the code selection
mode is canceled.
. If no action is taken for longer than 10 seconds
during the code selection procces the mode is
automatically canceled.
62
2-4. Entering Data into Memory
It is useful to put frequently used DTSS codes and
frequencies into memory. DTSS can then be used
simply by recalling memory. Separate data can be put
into each memory channel or call channel.
©) Entering data into memory
1. Press the F key.
2. Select a memory channel number with the tuning
control or microphone UP or DWN key while the F
indicator is on (10 seconds).
3. Press the MR/M key within 10 seconds.
©) Entering data into the call channel
1. Press the F key.
2. Press the CALL key while the F indicator is on (about
10 seconds).