Le Bont Ocaly Koe Cere Ee Fe - Kenwood TM-732A Instruction Manual

i SCAN
Each band can be scanned independently. For proper
scan operation the squelch must be adjusted to the
threshold point. Scan can not be used in conjunction
with the Tone Alert function.
The following scan options are available:
©) Band Scan
Scan proceeds over the entire band.
() Programmable Band Scan
The scan range in this mode is specified in
memory .
()Memory Scan —
Scan proceeds through those memory channels
that have data stored and have not been locked
out.
C)CALL / VFO Scan
Alternate scanning of the call channel and the VFO.
©) CALL / Memory Scan
Alternate scanning of the call channel and the
memory channel that was last used.
(©) MHz Scan
Scans over a1 MHz range.
40
Band Scan
. Press the BAND SEL key to select the desired band
. Adjust the SQL control of the band to the threshold
point.
. Hold down the VFO key for longer than 1 second
(for the VFO mode).
The MHz indicator will begin blinking, and scan will
begin.
. Scan will begin in an upwards direction. You can
reverse the direction of scan by turning the Tuning
control or pressing the microphone UP/DWN
keys. The tuning step size depends upon the current
Frequency Step selection.
. Scan will stop on a busy channel, i.e. a station that
is strong enough to open the squelch and turn on
the BUSY indicator.
. Press the microphone PTT switch or any other key .
Scan will then stop.
. You can scan both bands at the same time by -
repeating step 1 to 6 for the other band. Scan will
stop only on the band(s) that receive a signal. The
other band(s) will continue to scan.