I Ea; 6: Mhiz-'Scan - Kenwood TM-732A Instruction Manual

4. CALL Scan 6.
CALL / VFO Scan Two types of scan hold/resume have been provide
Press the CALL key for longer than 1 second in the this transceiver. The scan hold/resume can be set for
VFO mode to start alternate scanning of the VFO each band.
frequency shown on the display and the call channel. —-
: a Time Operated Scan (TO)
In this mode the radio stops on a busy channel,
remains there approximately 5 seconds, and then
NY continues to scan even if the signal is still present.
Carrier Operated Scan (CO)
In this mode the radio will stop scanning on a busy
CALL / Memory Channel Scan
Press the CALL key for longer than 1 second in the
memory channel mode to start alternate scanning of the
call channel and the memory channel that was last
used. | x
channel and remain there until the signal drops out.
The radio allows a 2 second delay before it resumes
scanning so that you don't lose the station when
operators change.
5. MHz Scan
1. Press the BAND SEL key to select the desired band.
2. Adjust the SQL control to the threshold point.
3. Start the band scan or programmable band scan. NOTES
4. Press the MHz key during band scan or 1. When the CTCSS is operating, scan will stop only
programmable band scan. on a signal which contains the proper CTCSS tone.
squelch turned off) whenever it receives a signal.
executed.
Example: If the MHz key is pressed when the Squelch will not open, however, until the proper
frequency is 145.02 MHz for VHF band scan, just the DTSS signal is received.
145 MHz band is scanned. 3. With both the CTCSS and the DTSS are turned on
scanning will stop when the proper CTCSS tone is
received. Squelch will open only if the DTSS signal
matches when scan stops.
42