DIP switch and jumper configurations
SW4.1 – Without valves control in FC config.
OFF - Enable valves control
ON - Disable valves control
SW4.2 – Not used
Always ON
SW4.3 – Not used
Always OFF
SW4.4 - End of line resistor (120Ω)
OFF = Not end of line
ON = End of line
SW1.1 through SW1.6, and SW3.1 through SW3.8
See Wiring and DIP switch/jumper settings (page 26).
ComfortVu™ BACnet Thermostat Model Standard TB-24 (24 Vac)Carrier Proprietary and Confidential
Installation and Operation Guide
JP2, JP3 – Outputs 15,16 – Analog
or Digital
JP2 – Output 16
Position 1- Analog output
Position 3- Digital output
JP3 – Output 15
Position 1- Analog output
Position 3- Digital output
23
CARRIER CORPORATION ©2024
All rights reserved