Error Messages - Panduit PES197 Manual

ERROR MESSAGES

In case of breakdown or operator error, the machine will show what caused the machine cycle interruption on
the display and on the monitor.
Contact technical support if code is not in table
ERROR MESSAGE
PWR-ON STAND BY STATUS-PRESS
E-00
START
E-01 OUT OF CARDS-PRESS START/FEED
E-02 CARD MISFEED-PRESS START/FEED
E-03 PUNCH MOTOR ERROR-CALL SERVICE
EMB. WHL ERR-CHECK CARD/PRESS
E-04
START
X MOT. ERR-CHECK CARD/PRESS
E-05
START
Y MOT. ERR-CHECK CARD/PRESS
E-06
START
E-10 PAUSE EMBOSSING-PRESS START
E-13 PUSHER MOTOR ERROR
E-50 DRUM WHEEL ERROR-PRESS START
PES197 & PES197/E: PA25609A01_04
PES197 and PES197/E: ENGLISH
CAUSE
MACHINE EXPECTING THE
RESET COMMAND
THE LOADER IS EMPTY
PLATES LOADED UPSIDE-
DOWN
THE CLAMP HAS NOT PICKED
UP THE PLATE
BRIGHT LIGHT ABOVE
EMBOSSER
EMBOSSING MOTOR BLOCKED
DRUM BLOCKED
PROBLEM ON THE CLAMP'S
TROLLEY
PROBLEM ON CLAMP
THE FRONT COVER HAS BEEN
OPENED
DIRTY SENSOR
DRUM MOTOR BLOCKED
Page: 15 of 18
SOLUTION
PRESS START, ANY OPEN
EASYMARK PRINT JOB MUST BE
CANCELLED AND RESTARTED
FILL THE LOADER
LOAD PLATES WITH EASY FEED
HUMPS FACING UP
CHECK FOR ANY DAMAGED
AND/OR MISFED PLATES AND
REMOVE
TURN OFF LIGHT OR SHADE THE
SENSOR
CALL TECHNICAL SUPPORT
CONTROLS THE PUNCHES, IF
PROBLEM PERSISTS CALL
TECHNICAL SUPPORT
CLEAN AND OIL THE TROLLEY
GUIDE AND CHECK THAT IT
MOVES FREELY
CLEAN AND OIL THE TROLLEY
GUIDE AND CHECK THAT IT
MOVES FREELY
CLOSE THE COVER AND PUSH
START
CLEAN SENSOR, CALL
TECHNICAL SUPPORT
CHECK THE PUNCHES AND
RETRY, IF PROBLEM PERSISTS
CALL TECHNICAL SUPPORT
1-2013