Table of Contents
Advertisement
HOPPER INSTALLATION
EXTERNAL HOPPER - NARROW TAG INSERT
a. Install External Hopper (see photo).
b. Install proper External and Internal hopper inserts to match marker plate height. (see photo).
c. Place appropriate plate weight on top of stack. Close machine cover by unlatching lock
mechanism located in the left rear of inside cover.
SWITCHING ON AND CONTROLLING THE DISPLAY
The machine can be switched on with the main switch (located in back of machine).
NOTE: Prior to switching "on", make sure cover is closed.
The display will appear with the message as shown below:
E-00 PWR-ON STAND-BY STATUS – PRESS START
Press the PAUSE/START key on left side of the front panel beside the display. This activates a general reset
which, when completed, will leave another message on the display to indicate the Ready state of the machine.
If the machine does not start, check that the power supply is correctly set and that the main fuse has not been
shorted.
If error message appears, please refer to the "Error Messages and Problem Solving" section.
NOTE: If the display is turned on but nothing appears on the screen,
switch the machine off and call for Technical Assistance.
(see Regional Contact Information on Page 18)
The machine is now ready to run.
PES197 & PES197/E: PA25609A01_04
PES197 and PES197/E: ENGLISH
PANDUIT METAL EMBOSSER V.#.##
READY
INTERNAL HOPPER - WIDE TAG INSERT
Page: 11 of 18
1-2013
Advertisement
Table of Contents
