Table of Contents
Advertisement
TROUBLE SHOOTING
Contact technical support for assistance with the following adjustments:
Gate Adjustment
Factory set to .014 ± .002". (Stainless Steel)
Factory set to .016 ± .002". (Aluminum)
Marker Plate Hold Down Adjustment
Factory set to .015 ± .003". (Stainless Steel and Aluminum)
OPTIONAL ACCESSORIES
1. Embosser for .020" thick metal marker plates: Consult factory
GENERAL MAINTENANCE
The operator should make a habit of doing general maintenance on the Embosser so as to ensure a correct and
long lasting functioning of the system.
ATTENTION! DANGER
The machine when at work has several moving units.
Do not work on the inside of the machine.
Do not remove the cover or guards except for the front cover which is used to load the
plates.
The maintenance should be done with the machine switched off.
Routine maintenance as listed below must be followed:
•
After the first 8 hours of embossing work, switch off the machine and remove the power
supply cable. Lift up the front cover and proceed as follows:
ATTENTION! DANGER
IMPORTANT: Do not remove the cover and the guards that are present inside the
embossing machine.
PES197 & PES197/E: PA25609A01_04
PES197 and PES197/E: ENGLISH
:
Page: 16 of 18
1-2013
Advertisement
Table of Contents
