Keyboard Description - Panduit PES197 Manual

KEYBOARD DESCRIPTION

The following list describes the 6 function keys and their actions:
SETUP: This key is used to access the programming menu or other internal functions of
the machine. A Password enables this command.
CARD TEST: This key enables the production of test plates with a pre-determined format.
It is done without the aid of the computer. Select desired test below; then press ENTER to
produce the plate.
The CARD TESTS for this machine are as follows:
NOTE: Test plates must be run on either MMP350 or MMP350H plates.
CARD TEST 0 – Embosses all the characters in the drum. It will use three plates to do this
CARD TEST 1 – Embosses an "L" in each corner of the plate.
CARD TEST 5 – Will emboss the Mechanical Parameters from the SETUP FILE using two
CARD TEST 6 – Embosses Letters on the plate.
CARD TEST 10 – A drum test embossing characters on two sides of the drum, going back
CARD TEST 11 – Embosses the numbers in the drum.
CARD TEST 14 – Will load and pick the plate, then unload the plate. No embossing.
ABORT: If this key is pressed the current operating cycle will be halted and the plate will be
unloaded.
DUP: If this key is pressed during a READY state and it is followed by ENTER, the
machine will repeat the last processed plate.
PAUSE: If this key is pressed the current operating cycle is blocked. Press START to
continue.
START: Clears any error condition which may have occurred during the current operating
cycle. A corresponding error message will be displayed on the LCD.
FEED: This key permits the operator to repeat the last plate should there be an error during
the production phase. Pressing this key will complete a paused cycle.
PES197 & PES197/E: PA25609A01_04
PES197 and PES197/E: ENGLISH
since the plates are small and only so many characters fit on each plate.
plates.
and forth.
Page: 13 of 18 1-2013